Using the System Setup Program and UEFI Boot Manager 65
PCI IRQ Assignments Screen
Serial Communication Screen
OS Watchdog Timer
(Disabled default)
Aids recovery of the operating system, if your system stops
responding. If set to Enabled, the operating system is
allowed to initialize the timer.
Embedded Video
Controller
(Enabled default)
Enables or disables BIOS support for the Embedded Video
Controller.
Option Description
<PCIe device> Use the <+> and <-> keys to manually select an IRQ
for a given device, or select Default to allow the BIOS to
select an IRQ value at system startup.
Option Description
Serial Communication
(On without Console
Redirection default)
Selects whether the serial communication devices
(Serial Device 1 and Serial Device 2) are enabled in
BIOS. BIOS console redirection can also be enabled and
the port address used can be specified.
Options are On without Console Redirection, On with
Console Redirection via COM1, On with Console
Redirection via COM2, and Off.
Serial Port Address
(Serial Device 1=COM1,
Serial Device2=COM2
default)
Sets the serial port addresses for the two serial devices.
NOTE: Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
External Serial Connector
(Serial Device1 default)
Specifies whether Serial Device 1, Serial Device 2,
or Remote Access Device has access to the external
serial connector.
NOTE: Only Serial Device 2 can be used for SOL. To use
console redirection by SOL, configure the same port
address for console redirection and the serial device.
Option Description
R415HOM.book Page 65 Friday, September 24, 2010 9:37 AM
To Next Page
Loading...
