Installing System Components 147
4
Replace all the memory modules. See "Removing Memory Modules" on
page 126 and "Installing Memory Modules" on page 124.
5
Holding the system board by its edges, lower it into the chassis.
CAUTION: Do not lift the system board assembly by grasping a memory module,
processor, or other components.
6
Slightly lift up the front of the system board and maneuver it to the
bottom of the chassis until it lays completely flat.
7
Push the system board toward the back of the chassis until the board is in
place.
8
Tighten the nine screws that secure the system board to the chassis.
SeeFigure3-32.
9
Replace the heat sinks and tighten the processor heat sink screws.
See "Installing a Processor" on page 130.
10
Connect the cables in the order listed below (see Figure 6-1 for the
locations of the connectors on the system board):
• SATA interface cable, if applicable
• Control panel interface cable connector
• Optical drive power cable connector
• Control panel USB interface cable connector
• SAS backplane power cable connector
• System board power cable connectors
11
Replace the expansion-card risers. See "Replacing an Expansion-Card
Riser" on page 107.
12
If applicable, install the expansion card. See "Installing an Expansion
Card" on page 101.
13
If applicable, re-install the integrated storage controller card.
See "Installing the Integrated Storage Controller Card" on page 104.
After connecting the SAS cables to the controller, make sure to place the
cables under the guide on the end of riser 1.
R415HOM.book Page 147 Friday, September 24, 2010 9:37 AM
To Next Page
Loading...
