Dell PowerEdge R415 - Removing a Hard Drive From a Hard-Drive Carrier

88 Installing System Components
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.
Figure 3-6. Removing and Installing a Hard Drive Into a Hard-Drive Carrier
Installing a Hard Drive Into a Hard-Drive Carrier
1 Insert the hard drive into the hard-drive carrier with the connector end of
the drive at the back. See Figure 3-6.
2 Align the screw holes on the hard drive with the back set of holes on the
hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
1 screw (4) 2 hard drive
3 SAS/SATA screw hole 4 hard-drive carrier
3
2
4
1
R415HOM.book Page 88 Friday, September 24, 2010 9:37 AM