EasyManua.ls Logo

Dell PowerEdge T20 - Page 18

Dell PowerEdge T20
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Option Description
System Password Max
Password Bypass Allows you to bypass the System Password and the internal HDD password prompts
during a system restart.
Disabled — Always prompt for the system and internal HDD password when they
are set. This option is disabled by default.
Reboot Bypass — Bypass the password prompts on restarts (warm boots).
NOTE: The system always prompts for the system and internal HDD passwords
when powered on from the off state (a cold boot). Also, the system always
prompts for passwords on any module bay HDDs that may be present.
Password Change Allows you to determine whether changes to the system and hard disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes — This option is enabled by default.
TPM Security This option lets you control whether the Trusted Platform Module (TPM) in the system
is enabled and visible to the operating system.
TPM Security — This option is disabled by default.
When the TPM Security option is enabled, it displays the following advanced options:
TPM ACPI Support
TPM PPI Deprovision Override
Clear
TPM PPI Provision Override
NOTE: Activation, deactivation, and clear options are not affected if you load the
setup program's default values. Changes to the TPM Security option take effect
immediately.
Computrace(R)
This field lets you activate or disable the BIOS module interface of the optional
Computrace Service from Absolute Software.
Deactivate — This option is disabled by default.
Disable
Activate
Chassis-Intrusion Allows you to enable or disable the chassis-intrusion alert.
Disable
Enable
On-Silent — This option is enabled by default.
Once a chassis intrusion has been detected, the system will add the chassis-intrusion
alert into the BIOS events at each cold/warm boot. The following option will then be
displayed:
Clear Intrusion Warning — This option allows you to acknowledge and clear the
chassis-intrusion status.
Processor XD Support Allows you to enable or disable the execute disable mode of the processor.
18

Table of Contents

Other manuals for Dell PowerEdge T20

Related product manuals