NOTE: If you assign a new system and/or admin password with the PSWD jumper installed, the system
disables the new password(s) the next time it boots.
5. Connect the system to the electrical outlet and power-on the system.
6. Power off the system and disconnect the power cable from the electrical outlet.
7. Remove the cover.
8. Replace the PSWD jumper on the system board.
9. Close the system.
10. Power on the system.
11. Go to the system setup, and assign a new system or admin password.
For information on assigning a system or admin password, see Assigning A System And Admin Password.
75
To Next Page
Loading...
