Table 5. Rear view of the system (continued)
Item Ports, panels, or slots Icon Description
12 System identification
button
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16 s.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold
the system ID button (for more than 5 s) to enter the BIOS
progress mode.
13 OCP NIC port (optional) N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
14 NIC port (1,2) The NIC ports are embedded on the LOM card that is connected to
the system board.
15 Power supply unit (PSU 1) For more information about the PSU configurations, see the
Dell EMC PowerEdge R750 Technical Specifications on product
documentation page.
NOTE: For more information, see the Dell EMC PowerEdge R750 Technical Specifications on the product documentation
page.
10 System overview
To Next Page
Loading...
