Dell PowerVault MD3200i - To Ensure E-Mail Is Sent Successfully

78 Configuration: About Your Storage Array
• Adding an e-mail address—In Email address , type the e-mail address,
and click
Add .
• Replacing an e-mail address—In the
Configured email addresses area,
select the e-mail address to be replaced, type the replacement e-mail
address in
Email address , and click Replace .
• Deleting an e-mail address—In the
Configured email addresses area,
select the e-mail address, and click
Delete .
• Validating an e-mail address—Type the e-mail address in
Email
address
or select the e-mail address in the Configured email addresses
area, and click
Test . A test e-mail is sent to the selected e-mail address.
A dialog with the results of the test and any error is displayed.
8 For the selected e-mail address, in Information To Send , select:
•
Event Only —The alert e-mail contains only the event information.
This alert type is the default.
•
Event + Profile —The alert e-mail contains the event information and
the storage array profile.
•
Event + Support —The alert e-mail contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
9 For the selected e-mail address, in Frequency , select:
•
Every event —Sends an alert e-mail whenever an event occurs. This is
the default option.
•
Every x hours —Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either
Event + Profile or Event +
Support
in the Information To Send drop down list.
10 Click OK .
An alert icon is displayed next to each node in the Tree view where an alert
is set.
To ensure that the e-mail is sent successfully:
• You must provide an SMTP mail server name and an e-mail sender address
for the e-mail addresses to work.
book.book Page 78 Saturday, September 24, 2011 9:06 AM