Dell PowerVault RD1000 - Using the Drive; Operating the RD1000 Unit; Handling the RD1000 Cartridges; Loading a Cartridge

Using the Drive
Operating the RD1000 Unit
This section describes typical activities involved in operating and maintaining the RD1000 unit. For
instructions on using your backup software, see the manual that came with your software.
Handling the RD1000 Cartridges
Although RD1000 cartridges are robust, the best practice is to handle them with extra care. This will
ensure data integrity and long life. Observe the following precautions:
 Store cartridges in their protective cases when you are not using them.
 Do not stack RD1000 cartridges.
 Keep cartridges away from dust, dirt and moisture.
 Avoid direct sunlight, heat sources and temperature extremes or rapid changes in
temperature.
 Never try to force the cartridge into the unit. If it is difficult to insert, check the orientation
and insure correct alignment using keyed corner as a guide.
Loading and Unloading Cartridges
The front of your unit has an opening for inserting RD1000 cartridges. A protective door covers the
opening. Below and to the right of the door is the power indicator that doubles as a cartridge-eject
button.
To Load a Cartridge
Insert the cartridge in the unit with the keyed corner facing the upper left corner of the unit and the
write-protect tab on the back right (see Figure 1). The cartridge only fits in one orientation. Push the
cartridge gently into the unit until it is locked in place with a clicking sound.