Dell Precision 3510 - Speaker Procedures; Installing the Speakers; Removing the System Board

Installing the speakers
1. Place the speakers into the slots on the computer.
2. Route the speaker cable through the retention clips through the routing channel.
3. Connect the speaker cable to the connector on the system board.
4. Install the:
a. dock frame
b. WLAN
c. WWAN
d. hard drive assembly or M.2 SSD or PCIe SSD
e. battery
f. base cover
5. Follow the procedure in After working inside your computer.
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. memory module
d. hard drive assembly or M.2 SSD or PCIe SSD
e. WLAN card
f. WWAN card
g. keyboard
h. dock frame
i. power connector port
3. Disconnect the speaker cables [1], touch pad and system board cables [2, 3] from the system board.
30