Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover Captive 9
Wireless card Captive 1
WWAN M2x3 1
M.2 2230/2280 Solid-state
drive thermal plate
M2x2 2
M.2 2230 Solid-state drive M2x4 1
Dummy Hard-drive filler M2x4 4
Hard drive M2x4 4
Hard-drive bracket M3x3 4
4-Cell battery M2x4 3
6-Cell battery M2x4 4
Assembly inner frame M2x3 17
2
Removing and installing components 11
To Next Page
Loading...
