Steps
1. Open the latch and disconnect the LED cable from connector on the sensor board.
2. Gently lift the sensor board away from the display back cover.
Installing the sensor board
About this task
The following image indicates the location of the sensor board and provide a visual representation of the removal procedure.
Steps
1. Align and place the sensor board on the display back cover.
2. Connect the LED cable to the connector on the sensor board and close the latch.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WWAN card.
5. Install the Wireless card.
6. Install the base cover.
7. Install the microSD card.
8. Install the SIM card.
9. Follow the procedure in After working inside your computer.
Display hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
112
Removing and installing components
To Next Page
Loading...
