Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the memory module.
6. Remove the 2280 solid-state drive or 2230 solid-state drive.
7. Remove the battery.
8. Remove the hard drive or dummy hard-drive slot filler.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the assembly inner frame.
12. Remove the speakers
13. Remove the system board.
NOTE:
The system board can be removed with the heat sink attached in order to simplify the procedure and preserve the
thermal bond between the system board and heat sink.
14. Remove the power-button board.
15. Remove the LED board.
16. Remove the smart card reader.
17. Remove the keyboard assembly.
18. Remove the display assembly.
19. Remove the dummy SIM-card slot filler.
About this task
The following image indicates the palm-rest assembly and provides a visual representation of the removal procedure.
Removing and installing components
121
To Next Page
Loading...
