Steps
1. Press the release tabs on the hard-disk drive bracket and align to insert the hard-disk drive assembly to the slot on the
computer chassis.
2. Connect the hard drive data and power cables to the connectors on the 3.5-inch hard-disk drive module.
3. Insert the tab on the PCIe card holder into the slot on the chassis and gently press down until it is secured to the graphics
card.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
Disassembly and reassembly
25
To Next Page
Loading...
