Steps
1. Insert the coin cell battery with the "+" sign facing up and slide it under the securing tabs at the positive side of the
connector.
2. Press the battery into the connector until it locks into place.
Next steps
1. Install the powered GPU.
NOTE: This step is required only if the system is configured with powered GPU.
2. Close the PSU cage
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Processor fan and heat-sink assembly
Removing the processor fan and heat-sink assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
WARNING: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the side cover.
3. Open the PSU cage.
About this task
The following images indicate the location of the processor fan and heat-sink and provide a visual representation of the removal
procedure.
Disassembly and reassembly
35
To Next Page
Loading...
