Dell Precision 3650 Tower - Intrusion switch; Removing the intrusion switch; Installing the intrusion switch

Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure.
Steps
1. Disconnect the intruder cable from the connector on the system board.
2. Slide and remove the intrusion switch from the chassis.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation
procedure.
40
Disassembly and reassembly