Installing the Slim-Optical Disk Drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the slim ODD and provide a visual representation of the installation procedure.
Steps
1. Insert the slim ODD assembly into the ODD slot.
2. Slide the slim ODD assembly until it snaps into place.
3. Route the power cable and data cable through the routing guides and connect the cables to the slim ODD.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
Disassembly and reassembly
29
To Next Page
Loading...
