Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Connect the intruder cable to the connector on the system board.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Front I/O panel
Removing the IO panel
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the front bezel.
4. Open the PSU cage.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure.
Disassembly and reassembly
41
To Next Page
Loading...
