Dell Precision 3930 Rack - Page 53

Installing the front Input Output panel
NOTE: Insure the front I/O panel is under the two guide clips (one on left side and another on the right side) or the panel will not
properly rest on the screw standos. The front I/O panel can be damaged if not properly installed.
1 Align the front I/O panel with the slots on the system chassis [1].
2 Replace the three (#6-32x5) screw that secures the front I/O panel to the system chassis [2].
3 Reconnect the Front panel cable [1], front panel HSD cable [2] and the front panel power cable [3].
NOTE
: Refer to cable routing picture or document and insure the three cables are properly routed from the I/O panel to the
system board.
Removing and installing components 53