4 Align the cables with the pins on connectors on the system board and connect power daughter board cable and front panel cable [1],
power daughter board power cable [2], front panel HSD cable, SATA power cable, SATA 0, SATA 1 (if disconnected) cable [3].
5 Reconnect the front panel power cable, GPU power cable [4].
6 Reconnect the SATA 2 power cable and the SATA 2, SATA 3 (if disconnected) cable and the GPU fan cables [5].
NOTE
: Route all cables through the retention clips provided on the system chassis and ensure no cables are stuck under the
system board during installation.
NOTE: Refer to cable routing picture or document and insure the cables are properly routed.
Removing and installing components 73
To Next Page
Loading...
