2 Align the screw holes on the I/O-board cable with the screw holes on the I/O-board interposers and adhere the I/O-board cable to
the fans [1].
NOTE
: When installing the I/O board cable, align and connect the I/O board end to the I/O board side and the system board
end to the system board side.
CAUTION: Wrong alignment of the cable might cause damage to the connectors.
3 Replace the four screws (M1.6x5.5) that secure the I/O-board cable to the system board [2].
24
Removing and installing components
To Next Page
Loading...
