Installing the heat sink
1 Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board [1].
2 In sequential order (as indicated on the heat sink), replace the ve screws (M2x3) that secure the heat sink to the system board [2].
3 Replace the screw (M2x3) that secures the heat sink to the palm-rest and keyboard assembly [3].
4 Place the heat-sink shield on the slots on the system board [1] and press down the heat-sink shield to snap it into place [2].
5 Ax the tape that secures the heat-sink shield to the system board [3].
Removing and installing components
27
To Next Page
Loading...
