3 Connect the antenna cables to the I/O board [1].
4 Place the wireless-antenna bracket on the I/O board and replace the two screws (M2x4) that secure the wireless-antenna bracket to
the I/O board [2].
5 Place the Type-C USB bracket on the I/O board and replace the three screws (M2x4) that secure the Type-C USB bracket to the I/O
board [3].
6 Connect the speaker cable to the I/O board [4].
7 Connect the LED and microphone cable to the I/O board [5].
Removing and installing components
35
To Next Page
Loading...
