4 Connect the coin-cell battery cable to the system board [1].
5 Connect the ngerprint-reader cable to the system board and close the latch [2].
6 Connect the keyboard-back light cable to the system board and close the latch [3].
7 Connect the display cable to the system board [4].
8 Place the display-cable bracket on the system board and replace the two screws (M1.6x1.8) that secure the bracket to the system
board [5].
9 Ax the tape that secures the display-cable bracket to the system board [6].
10 Connect the camera cable to the system board and close the latch [7].
48
Removing and installing components
To Next Page
Loading...
