Dell Precision Tower 7910 - Removing the Power Switch

6. Install:
a. front bezel
b. front cover
c. left cover
7. Follow the procedures in After Working Inside Your Computer.
Removing the Power Switch
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. left cover
b. front cover
c. front bezel
d. I/O panel
3. Perform the following steps:
a. Disconnect the power switch cable from the I/O panel board.
b. Press down on the power switch module on the sides to release the power switch from its
compartment [1,2].
4. Remove the power switch from the computer.
37