Setting Up the Monitor | 21
2
Setting Up the Monitor
Preparing the Stand
NOTE: The stand is attached when the monitor is shipped from the factory.
a. Place the monitor on a soft cloth or cushion.
b. Pull the monitor stand arm upwards clear of the monitor.
c. Place the monitor upright.
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section, follow the
Safety Instructions
.
NOTE: The VGA/DVI cable can be purchased separately.
NOTE: Do not connect all cables to the computer at the same time.
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
Connect the HDMI/DVI/VGA cable from your monitor to the computer.
To Next Page
Loading...
