Operating your monitor | 35
Dell SE2717H/HX
No VGA signal from your device.
?
Press any key on the keyboard or move the mouse to wake it up.
the correct input source.
If there is no display, press the monitor button again to select
If VGA or HDMI cable is not connected, a floating dialog box as shown below appears.
The monitor will enter Power Save Mode after 4 minutes if left at this state.
Dell SE2717H/HX
No VGA Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
or
Dell SE2717H/HX
No HDMI Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
See Troubleshooting for more information.
To Next Page
Loading...
