Dell Studio 1450 - Display Assembly; Removing the Display Assembly

Back to Contents Page
 Display
Display Assembly
Display Bezel
Display Panel
Display Panel Bracket



Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You Begin.

2. Remove the system board (see Removing the System Board).

3. Remove the WWAN module (see Removing the WWAN Module).

4. Remove the two screws at the base of the computer.

5. Remove the four screws (two on each side) that secure the display assembly to the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
screws (2)