Back to Contents Page
Replacing the Badge Back Light
DellStudioXPS™435T/9000ServiceManual
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Replacing the Computer Cover).
3. Remove the front panel (see Replacing the Front Panel).
4. Press the tabs away from the badge back light and lift the badge back light away from the front panel.
5. To replace the badge back light, align the holes in the badge back light to the projections on the front panel.
6. Press the badge back light down until it clicks in place.
7. Reconnect the badge back light cable.
8. Replace the front panel (see Replacing the Front Panel).
9. Replace the computer cover (see Replacing the Computer Cover).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
To Next Page
Loading...
