Dell Studio XPS 435T / 9000 - Replacing the Front Panel

Back to Contents Page
 Replacing the Front Panel
DellStudioXPS™435T/9000ServiceManual


1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Replacing the Computer Cover).

3. Push the lever to release the front panel from the computer.

4. Pivot the front panel away from the computer.

5. Disconnect the badge back light cable from the front panel.

6. Remove the badge back light (see Replacing the Badge Back Light).

7. Set the front panel aside in a secure location.

8. To replace the front panel, replace the badge back light (see Replacing the Badge Back Light).

9. Align the front panel with the front of the computer.

10. Push the front panel towards the front of the computer until it snaps into place.

11. Replace the computer cover (see Replacing the Computer Cover).
Back to Contents Page

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1
badge back light cable
2
front panel
3
lever


NOTE: Make a note of your computer's Service Tag/Express Service Code located on a label under the FlexBay panel. You will need the Service
Tag/Express Service Code to identify your computer when you call Technical Support.