Dell Vostro 5460 - Installing the Coin-Cell Battery; Removing the WLAN Card

Installing the Wireless Local Area Network (WLAN) Card
1. Insert the WLAN card into its connector at a 45–degree angle.
2. Tighten the screw to secure the WLAN card to the computer.
3. Connect the antenna cables to their respective connectors marked on the WLAN card.
4. Install :
a) battery
b) base cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the mSATA Solid State Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove :
a) base cover
b) battery
3. Remove the screw that secures the mSATA card to the computer.
4. Remove the mSATA card from its slot on the system board.
Installing the mSATA Solid State Drive
1. Insert the mSATA card into its connector at a 45–degree angle.
2. Tighten the screw to secure the mSATA card to the computer.
3. Install :
a) battery
b) base cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove :
a) base cover
b) battery
3. Disconnect the left system fan cable from its connector on the system board.
4. Remove the screws that secure the left system fan to the system board.
13