Dell Vostro 5460 - Installing the Memory Module; Removing the System Board

Installing the System Board
1. Place the system board into its original position on the chassis.
2. Install the screws that secure the system board to the chassis.
3. Connect :
a) camera cable
b) touchpad cable
c) keyboard cable
d) display cable
e) speaker cable
4. Install :
a) memory
b) heat sink
c) system fan
d) battery
e) base cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the Speakers
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove :
a) base cover
b) battery
c) hard drive
d) WLAN card
e) mSATA solid state drive
f) coin-cell battery
g) system fan
h) heat sink
i) system board
3. Disengage the tabs that secure the speakers to the chassis on both sides of the computer.
18