Dell Vostro 5470 - Installing the System Board; Removing the Speakers

Installing the System Board
1. Place the system board into its original position on the chassis.
2. Tighten the screws to secure the system board to the chassis.
3. Connect the following cable:
a) finger printer
b) WLAN
c) coin-cell battery
d) camera
e) touchpad
f) keyboard
g) display
h) speaker
4. Install:
a) hard drive
b) heatsink
c) system fan
d) battery
e) base cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the Speakers
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) base cover
b) battery
c) hard drive
d) WLAN card
e) mSATA SSD card
f) coin-cell battery
g) system fan
h) heatsink
i) system board
3. Un-route the speaker cable from the routing channel.
23