Installing the Speakers
1. Place the speakers into its original position on the computer.
2. Route the speaker cable along the routing channel.
3. Connect the speaker connector to its slot on the system board.
4. Install:
a) system board
b) heatsink
c) system fan
d) coin-cell battery
e) mSATA SSD card
f) WLAN card
g) hard drive
h) battery
i) base cover
5. Follow the procedures in
After Working Inside Your Computer.
Removing the Display Assembly
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove :
a) base cover
b) battery
3. Disconnect the LVDS cable and the camera cable from its connectors on the system board.
25
To Next Page
Loading...
