Installing the coin cell battery
1. Place the coin cell battery into the slot on the system board.
2. Connect the coin cell battery cable to the connector on the system board.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Solid State Drive
Removing the M.2 Solid-State Drive — SSD
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. To remove the solid-state drive (SSD):
a. Remove the M2.0 x 3 screw that secure the SSD to the system [1].
b. Lift and slide the SSD away from the system [2].
16
Removing and installing components
To Next Page
Loading...
