Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Identifier
GUID-E641BD48-9062-46FE-8F5A-723887A0921D
Version 2
Status Released
Display assembly
Identifier
GUID-4E7BE0FA-97BE-4C9E-96FF-8FB892551CA7
Version 1
Status Released
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
26
Removing and installing components
To Next Page
Loading...
