Next steps
1. Install the display assembly.
2. Install the solid-state drive.
3. Install the heat sink.
NOTE: The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
4.
Install the fans.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Identifier GUID-4AAEA62D-3F30-4E6E-ADEC-AD46B79B8EA6
Version 2
Status Released
Palm-rest and keyboard assembly
Identifier
GUID-E3DDE5C6-EA6C-4047-941F-6F1B51F1CC21
Version 1
Status Released
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the system board.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.
After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.
Removing and installing components
37
To Next Page
Loading...
