Identifier GUID-7FBB11D7-9820-47BB-AFAA-48FA912314D9
Version 1
Status Released
Removing and installing components
Identifier GUID-EA979CC8-84EC-4827-86C4-C80A8C31F4BF
Version 2
Status Released
Recommended tools
The procedures in this document may require the following tools:
• Phillips screwdriver #0
• Phillips screwdriver #1
• Torx #5 (T5) screwdriver
• Plastic scribe
Identifier
GUID-CC648B28-FBF9-4A6F-BB11-4C6C2FA3D08A
Version 5
Status Released
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest and keyboard
assembly
M2x3, Torx 5 8
Battery Palm-rest and keyboard
assembly
M1.6x2.5 5
Solid-state drive bracket System board M2x3 1
Fans System board M1.6x2.5 4
Display-assembly cable
holder
System board M1.2x2 3
Display-assembly hinges Palm-rest and keyboard
assembly
M2.5x4.5 6
System board Palm-rest and keyboard
assembly
M1.6x1.5 4
2
Removing and installing components 9
To Next Page
Loading...
