Identifier GUID-23FC0B54-4194-4AA0-94B3-32889535C89E
Version 1
Status Released
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
38
Removing and installing components
To Next Page
Loading...
