32 | Replacing the System-Board Shield
Replacing the System-Board Shield
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the system-board shield with the screw holes on
the middle cover.
2 Replace the screws that secure the system-board shield to the middle cover.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 18.
2 Follow the instructions in "After Working Inside Your Computer" on page 13.
OM_Book.book Page 32 Wednesday, April 3, 2013 1:39 PM
To Next Page
Loading...
