Replacing the VR heat sink
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align and place the VR heat sink on the system board.
2 Tighten the captive screws that secure the VR heat sink to the system board.
Post-requisites
1 Replace the blower and heat-sink assembly.
2 Follow the procedure from step 9 to step 10 in “Replacing the power-supply
unit”.
3 Replace the right-side cover.
92
To Next Page
Loading...
