Steps
1. Place the computer on its side with the left side facing up.
2. Disconnect the power-button cable from the system board.
3. Remove the screw (#6-32) that secures the power-button bracket to the chassis.
4. Remove the power button and its bracket from the slot on the chassis and thread the power-button cable through the slot
on the chassis.
5. Press the release tabs on the sides of power button to release it from the power-button bracket. If necessary, use the
flat-side of a scribe to lever the power button off the bracket.
6. Thread the power-button cable through the slot on the power-button bracket.
18
Removing and installing components
To Next Page
Loading...
