DeLonghi AN140EKF - Advanced Features and Remote Operation; Wi-Fi Functionality; Remote Control Operation

9
WIFI FUNCTION
ToactivateordisactivatetheWiFifunction,keepdepressedfor
fewsecondstheWiFibuttonindierentelyonthecontrolpanel
orontheremotecontroltilltheemissonofaprolongedbeep.
OncetheWiFiiconisdisplayeditmeansthattheWiFifeatures
areavailable.
 SYMBOL WIFI FIXED
 itmeansthattheWiFifeaturesareactiveANDthe
 “HomeWLAN” hasbeenfound.

 SLOW FLASHING
 itmeansthattheapplianceissearchingfor
 the “HomeWLAN” .
 FAST FLASHING
 itmeansthatthe “HomeWLAN” hasnotbeen
 foundorhasnotbeensetyet.
“APP CONTROL “ ICON
 WhentheAPPCONTROLiconappearsitmeans
 thatthelastcommandhasbeenreceivedviaapp.

Ifthememorized “HomeWLAN” settingsneedstobechanged,
proceedasfollows:
a) keeppressedforabout20secondstheWiFibutton(C4)un-
tiltheSC (SettingsCleared)messageisdisplayed;
b) usetheapptoenterthenewWLANsettingsintotheunit.

Whilesearchingforthe “HomeWLAN” ,thefollowingmessages
willappearonthedisplay:
• networkSearching
• networkLinked

OPERATING FROM THE REMOTE CONTROL
USING THE REMOTE CONTROL
• Pointtheremotecontrolat the receiver(A11)ontheair
conditioner.Theremotecontrolmustbenomorethan16
ft(5meters)awayfromtheappliance(withoutobstacles
betweentheremotecontrolandthereceiver).
• Theremotecontrolmustbehandledwithcare.Donotdrop
itorexposeittodirectsunlightorsourcesofheat.

NOTE: Theremotecontrolcanbesafelystoredintheappropiate
compartmentA12(seegure).
DESCRIPTION OF THE REMOTE CONTROL FIG. D
D1)
ON/STAND-BYbutton
D2) Increase/decreasetemperature/programmedoperation
D3) Fanspeedselectionbutton
D4) “MODE”selectionbutton
D5) Switchbutton°C/°F
D6) WiFi button

INSERTING OR REPLACING THE BATTERIES
• Removethecoverontherearoftheremotecontrol;
• Replacethe old batterieswithtwonew LR03“AAA”1.5V
batteries, inserting them correctly (see the instructions
insidethebatterycompartment);
• Replacethecover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment. Do not mix
MAX 16 ft
MAX 5 meters
D1
D5
D2
D6
D4
D3
D2
D