Access Door Module ADM-2W704 (Rev 1.3) Installation & Application Guide
Page 24 of 26 Access Door Module
COMMUNICATIONS SETUP
The Access Door Modules communicate on a LINKnet network at a default speed of 76,800 BPS. Refer to
the V3.30 Technical Reference Manual for further details on configuring the LINKnet network or changing
baud rates, etc.
See
RS-485 Network Installation Guide (DOC818-11) for details on wiring and terminating the LINKnet network
and devices.
CAUTIONS AND WARNINGS
The Access Door Module is an Electro-statically sensitive device. Proper ESD protection
(ground strap) should be used when installing this product so that damage to the product does
not occur.
To Next Page
Loading...