Delta Electronics ASDA-A2 Series - Page 263

Chapter 8 Servo Parameters
8-18 Revision January 2011
Monitor and General Use
Control Mode
Parameter Name Function Default Unit
PT PR S T
Related
Section
P0-39 MAP5A
Block Data Read / Write
Regis
ter 5 (for P0-29)
0x0 N/A
O O O O 4.3.5
P0-40 MAP6A
Block Data Read / Write
Regis
ter 6 (for P0-30)
0x0 N/A
O O O O 4.3.5
P0-41 MAP7A
Block Data Read / Write
Regis
ter 7 (for P0-31)
0x0 N/A
O O O O 4.3.5
P0-42 MAP8A
Block Data Read / Write
Regis
ter 8 (for P0-32)
0x0 N/A
O O O O 4.3.5
P0-46★
SVSTS Servo Output Status Display 0 N/A
O O O O -
P1-04 MON1
Analog Monitor Output
Proport
ion 1 (CH1)
100
% (full
scale)
O O O O 6.4.4
P1-05 MON2
Analog Monitor Output
Proport
ion 2 (CH2)
100
% (full
scale)
O O O O 6.4.4
Explanation of symbols (marked after parameter)
(
★) Read-only register.
(
▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(
) Parameter is effective only after the servo drive is restarted (after switching power off and
on).
(
) Parameter setting values are not retained when power is off.
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com