To Next PageTo Next Page
Need help?Do you have a question about the Delta Elektronika SM 15-100 and is the answer not in the manual?
General| Output Voltage | 0-15 V |
|---|---|
| Output Current | 0-100 A |
| Output Power | 1500 W |
| Efficiency | 88% |
| Cooling | Fan |
| Protections | OVP, OCP, OTP |
Covers cautions, live circuits, parts substitution, and fuse replacement guidelines.
Details grounding requirements for mains and DC power terminals for safe operation.
Covers installation category, AC input ratings, and environmental conditions.
Procedures for removing safety covers and relevant certifications (Canada, cTUVus, WEEE).
Covers output modes, input voltage/current, PFC, and autoranging.
Details efficiency, CV/CC regulation, ripple, noise, and RFI suppression.
Explains analog, isolated analog, and digital (Ethernet/IEEE488/RS232) programming.
Covers monitor outputs, status outputs, and status relay outputs.
Details function switches, remote shutdown, interlock, and thermal protection.
Guidelines for series, parallel, and master/slave operations.
Describes voltage/current limits, potentiometers, and the cooling system.
Covers operating temperature, insulation, dimensions, and handling pulsating loads.
Covers humidity, temperature, rack mounting, and first-time operation procedures.
Details analog, ISO AMP CARD, and digital programming configurations.
Covers remote sensing, battery charging, remote shutdown, and master/slave operations.
Explains master/slave series, parallel, and mixed operations.
Contacting support, checking basic output and programming issues.
Diagnosing programming errors, offsets, and status output failures.
Understanding OT, ACF, DCF, PSOL LEDs and troubleshooting no/blinking LEDs.
Troubleshooting master/slave parallel problems and high output voltage issues.
Keeping the unit clean and unobstructed; inspecting fan/heatsink.
Covers meter calibration and special calibrations like current monitor offset/scale.
Precautions for using units in aggressive galvanic industry environments.
