Page 5 of 12
Copyright © 2020 Delta-Q Technologies Corp
SAFE OPERATING INSTRUCTIONS
• The charger contains up to 25 selectable charging algorithms stored in its internal memory to charge
batteries. These algorithms are specific to each manufacturer and model of battery. Your equipment
supplier or charger distributor is responsible for ensuring the active charge algorithm matches the battery
pack charging requirements. Contact them
with any questions about which algorithm to select for each
battery pack.
•
The charger may become hot during charging. Use hand protection to safely handle the charger when
charging.
•
To maintain safe operations, the unit automatically reduces its output power if the temperature rises
above set thresholds, or if the AC input voltage is too low.
•
If power is interrupted, and then returns, the charger restarts and continues to operate without hazard to
the user, or damage to the batteries.
•
Unplug the charger from both AC and DC sources when cleaning, moving, or conducting any maintenance
or repair on the charger. No user serviceable parts are inside. Do not remove the cover due to the risk of
electrical shock.
•
Do not expose the charger to oil, dirt, mud, or direct heavy water spray when cleaning the vehicle or
machine.
•
If the detachable AC input power cord set or DC output cord is damaged, do not use the charger until they
are
replaced with cord sets appropriate to your region and application.
•
When mated with a Delta-Q Technologies sealed AC cord, the charger meets IP66 specifications, making
it dust-tight and protected against powerful water jets. If a cord set with an unsealed connector is used, the
plug and connector must be periodically inspected to ensure the contacts are clean and dry.
o
If this charger is provided with an AC cord set and the power plug does not match the power outlet,
contact the equipment manufacturer, distributor,
or Delta-Q Technologies for the correct
AC cord set
terminating with a 3-prong
plug suitable for your region’s grounded power outlet.
o
In North America (and other 120V AC regions),
the AC cord must be a 3-conductor UL Listed/
CSA approved detachable cord set at least 1.8m
in
length (≥ 6 feet), minimum 16 AWG and rated
SJT; rated 105˚C min, and terminated with 125V,
13A, or greater connector.
o
In Japan, the AC cord must be a 3-conductor PSE
approved detachable AC cord set, rated 105˚C,
and terminated with 100V,
15A, or greater
connector.
o
In 220-240VAC regions, the AC cord must be a 3-conductor safety-approved cord set, with
1.5mm² conductors (min.), rated appropriately for industrial use. The cord must be terminated on one
end with a grounding type input plug appropriate for use in the country of destination; both plug and
connector should be rated 250V, 10A, or greater.
•
Extension cords must be 3-wire cords no longer than 30m (100’) at 10 AWG or 7.5m (25’) at 16 AWG, per
UL guidelines.
To Next Page
Loading...
Need help?
General
