Delta-q QOSY - Alerts and Alarms; Understanding Machine Alerts

EN INSTRUCTIONS AND MODE OF USE
100
• Select the intended temperature by pressing one the extraction buttons,
to the following preset information:
Express coee button (B): Minimum temperature
Long coee button (C): Medium temperature
Tisane button (D): Maximum temperature
• The selected button blinks twice conrming that the operation was
successful.
The equipment automatically returns to “Ready to use” mode (see Fig.8).
Note: If the user fails to press one of the extraction buttons for temperature
selection, the equipment will automatically take the factory default temperature.
Programming the original settings
Note: The predefined factory volumes for extraction buttons are approximately:
Espresso coee: 30cc
Coee: 45cc
Tea: 180cc (non-programmable button)
To return the equipment to original factory settings, ensure the machine is ON
(see Fig. 6), check whether there is any water in the water tank and wait until
the control panel buttons indicate “Ready to use” (see Fig. 8).
• Then press the espresso coee and tea extraction buttons simultaneously
for 3 seconds. All the buttons on the control panel illuminate orange and
flash three times (see Fig. 21).
• As soon as the buttons stop ashing factory settings have been reset.
After attaining the correct temperature, the equipment returns to the
“Ready to use” mode (see Fig. 8).
Fig. 21: Programming the original
setting of the extraction buttons.