EN INSTRUCTIONS AND MODE OF USE
98
PERSONALISED SETTINGS
The control panel buttons can also be used to personalise the dosages of the
dierent drinks.
Programming the espresso coee extraction button.
Note: The pre-defined factory volume for the espresso coee extraction
button is around 30cc.
• To alter the volume of your short drink, ensure the machine is ON (see Fig. 6),
check whether there is any water in the water tank and wait until the control
panel buttons indicate “Ready to use” (see Fig. 8).
• Then press the espresso coee extraction button for 3”.
The luminous indicator of the Standby button changes from green to
orange and the luminous indicators of the coee and tea extraction buttons
go o. Press the espresso coee extraction button which starts flashing
(green) and sets extraction in motion (see Fig. 18).
• As soon as extraction has reached the desired dosage, press the espresso
coee extraction button again and the operation is complete.
The equipment memorises this volume and will start extracting it until new
programming has been defined.
• After completing extraction, the equipment returns to “Ready to use” mode
(see Fig. 8).
Note: If the user fails to press the extraction button to complete the operation,
the equipment will automatically assume the maximum volume of 65cc.
Fig. 18: Programming the espresso
coee extraction button (short).