23
Fig. 66
10. If using the saw on a workbench (See Fig. 68) or on
saw horses (See Fig. 70), re-assemble the two table
extensions, one of which is shown at (J) Fig. 66, that
were removed in STEP 6. If you are using the saw on
2 x 4 wooden extensions (See Fig. 71), push in the four
table extension rods, two of which are shown at (O)
Fig. 66, and lock in place. In this case it is not necessary
to replace the table extensions (J).
O
O
J
FASTENING THE SAW TO A WORKBENCH
(FOR ALL MODELS)
Figs. 67 and 68, illustrate the slide saw fastened to a workbench. Holes provided in the base of the units (A) Fig. 67
and (B) Fig. 68, are used to mount the machines to a supporting surface using standard hardware. FOR MODEL
36-250 ONLY: Please note that the table extensions and auxiliary fences (A) Fig. 68, can also be used.
Fig. 67
Fig. 68
A
A
A
B
To Next Page
Loading...
