26
Fig. 75
Fig. 76
Fig. 77
Fig. 78
3. Push down on the cuttinghead (C) Fig. 75, with the
blade running, as shown.
4. Push the cuttinghead (C) Fig. 76, forward toward the
fence, making the cut as shown.
5. Figure 77 illustrates the completed cut. Release the
switch trigger and keep the cuttinghead in the down
position until the blade (D) comes to a complete stop.
6. After the blade has stopped, raise the cuttinghead
(C) to the up position, as shown in Fig. 78.
C
C
D
C
To Next Page
Loading...
